Uline H-10357 Instructions D'assemblage page 9

CONTROLS
Display
CAUTION! Ensure there are no obstacles in the desk's height adjustment path, and ensure the desk is not
touching any walls.
CAUTION! Ensure all cords are at the appropriate length to accommodate changes in height.
HEIGHT ADJUSTMENT
• Press the up button to raise the desktop.
• Press the down button to lower the desktop.
• Release button to stop movement.
CAUTION! To avoid overheating, do not move the desk up and down continuously for over two minutes
within any 20-minute period. If the desk overheats, HOT will be displayed on the handset. Stop using the
desk for 20 minutes and let it cool down.
PROGRAMMING PRESET HEIGHT
• Use up and down buttons to move desk to the desired position.
• Press the "M" setting button to display "
S-1 S-2
" ", " ", etc. will be displayed.
• Up to four presets can be programmed.
PROGRAMMING HEIGHT LIMITS
NOTE: Desk is equipped with a height limit function. This function allows upper and lower height limits to be
programmed. This can be used to prevent collisions with objects above and below the desk, such as file
pedestals and overhead cabinets.
NOTE: Lower height limit is factory preset to be level with main desktop and should not need to be adjusted.
NOTE: Always program height limits before programming preset heights.
• Use up and down buttons to move desk to the desired upper height limit.
• To set the upper height limit, press "M" setting button to display "
once. Press and hold the "M" setting button until "
• Use up and down buttons to move desk to the desired lower height limit.
• To set the lower height limit, press the "M" setting button to display "
flash once. Press and hold the "M" setting button until "
• To cancel the height limits, press the "M" setting button to display "
displayed. The height limits are now canceled.
PAGE 9 OF 33
OPERATION
Up Down
Button Button
1 2 3 4 M
S-
". Press the desired preset position button to store the preset height.
999
Four Preset Setting
Position Buttons Button
S-
". Press the up button and the display will flash
" is displayed. The upper height limit is now set.
S-
". Press the down button and the display will
000
" is displayed. The lower height limit is now set.
S-
". Press and hold the "M" button until "
USB
Charger
1
2 3 4
M
555
" is
0223 IH-10357