Uline H-10357 Instructions D'assemblage page 7

L-DESK RETURN AND ADJUSTABLE HEIGHT BASE ASSEMBLY CONTINUED
12. Check bottom of return leg frame (5) to determine
whether to use foot bracket with three holes (Q) or with
four holes (P). Align holes in foot bracket (P, Q) with
holes on return leg frame and foot (13). Depending
on foot bracket, insert three or four M6 x 16 mm
bolts (M) and tighten. (See Figure 16)
NOTE: Second person should keep return frame
lifted to correctly align the foot bracket.
Figure 16
M
M
P
5
13. Place programmable handset (7) on front edge of
return desktop (4). Attach using a drill and two ST5 x
16 mm screws (O). (See Figure 17)
Figure 17
4
7
PAGE 7 OF 33
Q
P
M
13
13
O
14. Insert control box (10) into center frame (9). Slide
plastic tabs of control box into plate on center frame
to lock in place. (See Figure 18)
Figure 18
10
9
15. Connect the power cord (R) to the control box (10).
Plug the programmable handset (7) and lifting
column cables into the control box. (See Figure 19)
Figure 19
R
7
Lifting Column Cables
Power Cord
10
9
10
Handset
Cable
0223 IH-10357