AENO TB2 Mode D'emploi page 16

---
One program
indicator: soy
milk, rice paste,
corn, soup,
fruit/vegetables,
smoothies
---
---
Troubleshooting
The smell of burning plastic or rubber. Possible causes: the appliance motor
is inside the housing under strong rubber materials to reduce noise and
vibration. The first few starts, the parts of the appliance will be hot and emit an
unpleasant odor. Later on, the smell will disappear. Solution: It is recommended
to install the blender in a well-ventilated room.
The products are badly chopped. Possible causes: low mains voltage; too
much or too little food in the bowl; not enough water in the bowl. Solution: plug
the appliance into an outlet with a supply voltage of at least 220 V, use a voltage
regulator; remove excess food from the bowl or add water to it.
The liquid pours over the edge of the blender bowl. Possible causes: too
much liquid. Solution: make sure that the amount of liquid does not exceed
the maximum level specified in the instructions.
16
All indicators
"ON/OFF",
"FUNCTION"
"PRESET TIME" +
one of the program
indicators
"CLEANING"
(cooking time of the
selected product)
Operating time in
seconds
aeno.com/documents
Standby
mode
Program
selection
Delayed
start
Cleaning