AENO TB2 Mode D'emploi page 14

Preparing for operation
Wash the blender bowl, large lid and small lid with warm soapy water
and wipe it dry.
WARNING! Never allow water to get to the bottom of the base of the blender
cup. Short circuit of electrical contacts will occur and the device will break down.
Place the bowl on the blender housing (See figures a and d). The bowl
connector must fit into the groove of the blender housing , and the motor
shaft connector must fit into the blade shaft connector on the bottom of
the bowl base . At the same time, the rubber compensators should enter
the recesses of the bowl base.
NOTE. If the bowl can not be installed on the blender housing, remove it from
the base and twist the motor shaft connector in the blender housing by hand
half a turn in either direction.
Operating the device
Place food in blender bowl. Then place the large lid in the bowl and turn it
clockwise until the grooves on the large lid align with the protrusions on the
bowl (See figures a and b). After that insert the small cap into the large cap
and turn it clockwise (See picture c). To open the large and small lids turn them
counterclockwise.
NOTE. The device will immediately stop working if you open the large lid. If you
need to add food or spices while the blender is running, you can open the small
lid to do so. Use the measuring cup to dose spices and other products. You can
find recipes of various dishes in the full instructions at aeno.com/documents.
Plug the device into a power outlet. Power control mode will turn on. Press the
"ON/OFF" (Start/Stop) button to switch to standby mode. Select one of the six
blender programs by pressing the "FUNCTION" (Select a program) button.
Then press the "ON/OFF" button (if you do not press the button within
14 aeno.com/documents