Publicité
Les langues disponibles
Les langues disponibles
30 seconds, the blender will go into standby mode). After that the selected
program will start. You can control the program run time in minutes and
seconds on the display
button and unplug the blender.
NOTE. The maximum continuous operation time is 5 cycles. In case of longer
use, engine will be automaticly blocked. To resume work, you must disconnect
the device from the power supply, remove the bowl and wait for no longer then
10 minutes. After this time, the device will be ready for use again.
You can also turn on the device in delayed start mode. To do this in standby mode
you must first set the desired time before starting the program with the "PRESET
TIME" button. Each press of this button increases the time until the blender starts
by 30 minutes. Then select the desired program with the "FUNCTION" button and
then press the "ON/OFF" button. The blender will start itself after a set period of
time, work the selected program, and then go into standby mode.
NOTE. If you set the wrong time before the blender starts, you can cancel the
setting with the "ON/OFF" button.
The self-cleaning mode helps to clean the blade from stuck food peaces. To do
this, you need to remove food from the blender, pour 500ml of warm water
with a little dishwashing detergent into the blender and press the "CLEANING"
button. The blade will rotate as long as you hold down the "CLEANING" button.
When the cleaning is finished, rinse the bowl with warm running water.
Device mode indication table (See figure e):
LED indicator,
blinking
"ON/OFF"
aeno.com/documents
. When the process is finished, press the "ON/OFF"
LED indicator,
lights up
---
Digital display
Mode
Power
control
15
Publicité
