Structure Illustration; Transport And Handling - MaxxHome 21993 Mode D'emploi

STRUCTURE ILLUSTRATION

1. Top cover
2. Glass shelf in freezer
3. Light & Thermostat knob
4. Wine shelf
1
5. Glass shelf
2
3

TRANSPORT AND HANDLING

4
When transportation, hold the base and lift the refrigerator carefully with an angle
5
inferior at 45 degree. Never hold the door handle as support. Never place it upside
down nor horizontally. Push refrigerator on its basis and place it thanks to its roller feet.
INSTALLATION
To fix stably, the appliance must be placed on a flat and solid surface. It should not
be laid on any soft material. Choose a well-ventilated place. A space of at least 5cm
must be left at the sides and 10cm at the back of the refrigerator. Choose a location
where there is no heat source. Keep the refrigerator away from direct sunlight or other
appliance producing heat. Choose a dry and well-ventilated place where there is no
corrosive air.
TEST
Clean the parts of the refrigerator with lukewarm water on a soft cloth or with a neutral
detergent and with clear water, then wipe them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry cloth. Turn the thermo-
stat knob on the "3" position and turn on electricity. The compressor and the light inside
the refrigerator begin to work. Close the door and wait 30 minutes. If the temperature
in the freezer compartment decreased obviously, it shows that the refrigerator system
works well. When the refrigerator operates for a period of time, the temperature
controller will automatically set the temperature on conditions that the door is not
too often opened. If the above steps are successful, the trial operations are finished.
The refrigerator works normally.
6. Crisper
7. Adjustable feet
8. Freezer door
9. Small door rack
Top cover
10. Bottle rac
Glass shelf in freezer
Light & Thermostat knob
Wine shelf
Glass shelf
6. Crisper
7. Adjustable feet
8. Freezer door
9. Small door rack
10. Bottle rack
23