Table des Matières
Publicité
Before you light the heater, check the
following points:
The combustion cylinder must be proprely positioned. Make
it rotate pushing the lever from left to right and make sure it
is correctly fitted.
When you use the heater for the first time, odours may
persist for a certain time after lighting. This is normal, as oil
and protective grease in the heater have to be burnt off.
Slowly push the ignition lever downwards until the START
position . (To await the "beep")and maintain to it 1 to 2
seconds until the flame is visible.The wick will rise and the
heater ignites automatically. Check visually through the
glas burner cylinder that the heater is alight. After having
carried out the ignition procedure, there may be some white
smoke coming out of the ignition zone, without the heater
being lit. In this case, move up the ignition lever part way
through its travel and the heater will start to operate. This
operation must be done slowly and gently.
Try several times if lighting is not carried out in the 1 or 2
seconds. In the event of insistence, you risk to roast the ligh-
ter or the wick (spare parts non garanted).
CAUTION: NEVER LIGHT YOUR HEATER WITH
MATCHES OR A LIGHTER OR OTHER FIRES
LIGHTING THE HEATER
60
Publicité
Table des Matières
