Brita PURITY 450 Quell ST Mode D'emploi page 12

Resetting the display unit
To operate the display unit it has to be removed from the connecting fittings. Slide the display housing
up approx. 10 mm and remove the display unit by pulling it forward. The display unit is operated using
a button on the back of the display unit.
• If this button is pressed (> 10 sec), the data set on
initial installation will be applied again and the capacity,
by-pass setting and input date will all be updated.
Note: This automatically sets the monthly limit to 12 months.
Note: If there is no entry after more than 30 seconds the display returns to operating mode without
applying the changed parameters.
Insert the display unit from the front at a height of approx. 10 mm and slide down. The loops on the
display part must be inserted into the grooves on the measuring head.
5 Removing the filter cartridge
•
Switch off the unit's power supply (remove plug).
•
Close inlet valve
•
Place the flushing hose in a bucket and remove pressure from the filter system by opening the
flush valve. Catch the escaping water in a bucket.
Note: Insert the free end of the flush hose in a bucket. If the discharged water is more than
0.5 litres, the inlet value is not completely closed or is blocked with scale.
EN
•
Place the pressure vessel lid
Note: Do not turn the lid horizontally on its head.
• Keep both feet on the kick loops
•
Stand on the kick loops
by the mantle handles
•
Take your feet off the kick loops and push the pressure vessel down with both hands on the
mantle handles
•
Remove exhausted filter cartridge
• Place the exhausted filter cartridge
drainage (> 5 min.).
• Lock the exhausted filter cartridge
and return in the original packaging to the appropriate BRITA address listed on the back of the cover.
12
at inlet hose.
7
•
Stand on the kick loops
lid by pressing the lock
3
The filter cartridge
vertically on both lid handles
3
.
12
with both feet while turning the pressure vessel
12
as far as it will go.
16
.
16
2
with the transport protective cap
2
> 10 sec
with both feet while opening the pressure vessel
12
and turning it anticlockwise as far as it will go.
15
is released by pressing on the mantle handle
2
from the pressure vessel
in the sink with the connection facing down for
2
.
20
anticlockwise
1
.
1
of the new filter cartridge
18
.
16