Troubleshooting - Toro Power Max e24 Manuel De L'utilisateur

Troubleshooting

Problem
The machine does not run or does not run
continuously.
The machine does not reach full power.
The machine runs, but the machine
discharges snow poorly or not at all.
The discharge chute either does not lock
into place or does not move.
The machine does not properly clear the
snow off the surface.
The battery pack loses charge quickly.
The battery charger is not working.
Possible Cause
1. The battery pack is low on charge.
2. The battery pack is not fully seated.
3. The battery pack is over or under the
appropriate temperature range.
4. The battery pack has exceeded high
amperage limits.
5. There is moisture on the leads of the
battery pack.
6. The battery pack is damaged.
7. There is another electrical problem
with the machine.
1. The battery pack charge capacity is
too low.
2. The air vents are blocked.
1. The machine is moving too fast to clear
the snow.
2. You are trying to remove too much
snow per swath.
3. You are trying to remove extremely
heavy or wet snow.
4. The discharge chute is plugged.
5. The auger/impeller drive belt is loose
or is off the pulley.
6. The auger/impeller drive belt is worn
or broken.
1. The discharge-chute latch cable is not
properly adjusted.
1. The skids and/or scraper are not
properly adjusted.
2. The pressure in the tires is not equal.
1. The battery pack is over or under the
appropriate temperature range.
2. The machine is overloaded.
1. The battery charger is over or under
the appropriate temperature range.
2. The outlet that the battery charger is
plugged into does not have power.
30
Corrective Action
1. Charge the battery pack.
2. Ensure that the battery pack is inserted
all the way into the housing.
3. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
4. Release the trigger, then press the
trigger switch.
5. Allow the battery pack to dry or wipe it
dry.
6. Replace the battery pack.
7. Contact an Authorized Service Dealer.
1. Remove the battery pack from the
machine and fully charge the battery
pack.
2. Clean the air vents.
1. Shift the machine into a lower gear.
2. Reduce the amount of snow removed
per swath.
3. Do not overload the machine with
extremely heavy or wet snow.
4. Unclog the discharge chute.
5. Install and/or adjust the auger/impeller
drive belt; refer to www.Toro.com
for servicing information or take the
machine to an Authorized Service
Dealer.
6. Replace the auger/impeller drive belt;
refer to www.Toro.com for servicing
information or take the machine to an
Authorized Service Dealer.
1. Adjust the discharge-chute latch cable.
1. Adjust the skids and/or the scraper.
2. Check and adjust the pressure in 1 or
both tires.
1. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
2. Push the machine with less force.
1. Unplug the battery charger and move
it to a place where it is dry and the
temperature is between 5°C (41°F)
and 40°C (104°F).
2. Contact your licensed electrician to
repair the outlet.