MINN KOTA MKA-16-03 Instructions D'installation page 9

8
k. Replace the Right Sideplate.
l. Replace the Left Sideplate.
m. Replace the four sideplate Screws using a #2 or #3
Phillips Screw Driver.
8l
Left Sideplate Left Sideplate
Screw Screw
Installing the Bottom Plate
1
a. Place the mount with the Quick Release Bracket
attached as close to the center line or keel of the
boat as possible. The motor can be installed on
either the Port or Starboard side of the boat based
on personal preference. Check placement with the
motor in the stowed and deployed positions. Review
the mounting considerations at the beginning of
the installation.
b. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale of
the boat. The lower unit, when stowed and deployed
must not encounter any obstructions.
NOTICE:
Make sure that the motor will not
encounter any obstructions when sliding the motor
on and off the quick release bracket. The exact
placement of the motor and quick release bracket
when mounting may vary depending on the boat,
boat deck, and which base extrusion or bracket
the quick release bracket is being mounted to. The
Ulterra motor cannot be deployed before mounting
and connecting a power source.
9 | minnkotamotors.com
Screw Screw
8k
Screw Screw
1a
1b
Gunwale Gunwale
Screw Screw
Right Sideplate Right Sideplate
Keel Keel
Deck of Deck of
Boat Boat
Shaft Shaft
1-1/2" 1-1/2"
Minimum Minimum
©2020 Johnson Outdoors Marine Electronics, Inc.