MINN KOTA MKA-16-03 Instructions D'installation page 4

4
ITEM(S) NEEDED
f. Take the Quick Release Bracket Assembly
(Assembly #A) and remove the Tension Screw Knob
and Lock Washer. Set the Tension Screw Knob and
the Lock Washer aside to reassemble later.
g. Slide the Top Plate and the Bottom Plate and notice
the range of motion allowed in the bracket, and the
position of the bracket when it is completely closed.
The Socket Head Cap Screw stops the motion of the
brackets when closed. Slide the plates completely
apart and set the Bottom Plate aside.
CAUTION
Watch for pinch points when sliding the top and bottom
plates of the Quick Release Bracket.
h. On the Top Plate, take note of the placement of the
single Socket Head Cap Screw already attached to
the plate. When the Top Plate is attached to the
Base Extrusion, the screw will sit under the mount
closest to the end where the Power Cord exits the
base of the Mount.
5
ITEM(S) NEEDED
#14 x 4
i. Take the Top Plate and turn it so the flat side faces
upwards. Align the Mounting Holes in the Top Plate
with the Mounting Holes in the Base Extrusion that
were exposed when the sideplates were removed.
Make sure that the Socket Head Cap Screw is
located on the mount closest to the Power Cord.
The appearance of your Base Extrusion may vary
depending on motor type.
j. Use the 1/4 -20 X 7/8 Hex Head Cap Screw (Item
#14) and Nylock Nuts (item # 16) to secure the Top
Plate to the Base Extrusion. It is recommended to
use a minimum of two bolts on each side, placing
them the farthest apart on the mount. The screws
will pass from the bottom up, through the Top Plate
and then the Base Extrusion. The Nylock Nuts are
placed on the screws on top of the Base Extrusion
and tightened with the 7/16" Box End Wrench.
Make sure all hardware is secure.
4 | minnkotamotors.com
#A x 1
#16 x 4
4f
Quick Release Bracket Assembly Quick Release Bracket Assembly
Bottom Bottom
Plate Plate
Slide Slide
Socket Head Socket Head
Cap Screw Cap Screw
Lock Washer Lock Washer
4h
Power Cord Power Cord
Socket Head Cap Screw Socket Head Cap Screw
Nylock Nuts Nylock Nuts
Power Cord Power Cord
Exits Here Exits Here
Mounting Mounting
Holes Holes
Inboard Inboard
Hex Head Hex Head
Cap Screw Cap Screw
NOTICE:
To prevent seizing of the stainless steel hardware,
do not use high speed installation tools. Wetting the screws
or applying an anti-seize may help prevent seizing.
Top Plate Top Plate
Tension Tension
Screw Knob Screw Knob
Top Plate Top Plate
Base Base
Extrusion Extrusion
Outboard Outboard
Mounting Holes Mounting Holes
Top Plate Top Plate
Hex Head Hex Head
Cap Screw Cap Screw
©2020 Johnson Outdoors Marine Electronics, Inc.
Slide Slide