MINN KOTA MKA-16-03 Instructions D'installation page 6

Installing the Top Plate to a Pontoon Hand Control Bracket
1
ITEM(S) NEEDED
a. Position the Pontoon Hand Control Bracket over the
Top Plate (Assembly #A) and mount the Bracket
using only the four holes that are farthest Outboard
on the Top Plate. The two holes closest inboard are
not used to install the Bracket.
b. Take four Hex Head Cap Screws (Item #14) and
insert them from the bottom of the Outer Plate
through the Pontoon Hand Control Bracket. Secure
each Screw with a Nylock Nut (Item #16). The Hex
Head Cap Screws should face inboard.
Installing the Top Plate to an Ulterra
1
WARNING
Make sure that the Power Cables from the battery are
disconnected, or that the breaker, if equipped, is "off."
NOTICE:
A motor may weigh up to 65lbs. We
recommend having a second person help with the
installation.
a. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor should be in the stowed position.
NOTICE:
Ulterra installation will use hardware that was
included with the Ulterra motor. The hardware needed
will be six Stainless Steel Screws (Part #2203431) and
six Clipped Washers (Part #2201725) from the Ulterra
bag assembly (Part #2994917).
6 | minnkotamotors.com
#A x 1 #14 x 4
1a
Mounting Mounting
Inboard Inboard
Power Cables Power Cables
#16 x 4
1b
Outboard Outboard
Nylock Nylock
Holes Holes Nut Nut
Pontoon Pontoon
Hand Control Hand Control
Bracket Bracket
Outer Outer
Plate Plate
Inboard Inboard
Deployed Deployed
©2020 Johnson Outdoors Marine Electronics, Inc.
Outboard Outboard
Hex Head Hex Head
Cap Screw Cap Screw
Stowed Stowed