MINN KOTA MKA-16-03 Instructions D'installation page 7

2
b. Using a #3 Screwdriver, remove the Sideplates to
access the Mounting Slots.
3
c. Under the Left Sideplate, the Extension Damper
obstructs access to the left front Mounting Hole.
d. Using a small Screw Driver, remove the two
5/16" e-clips holding the Extension Damper in place.
Once the e-clips are removed, slide the Extension
Damper off the Damper Pins to expose the left rear
Mounting Hole. Set the two e-clips and Extension
Damper in a safe place so they are not misplaced
before they are reassembled later in the installation.
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor
before it is mounted to the boat may cause injury.
4
NOTICE:
The Hex Head Bolts (Item #14) and
Nylock Nuts (Item #16) that came with the
MKA-16-03 are not used when installing the
Bracket to an Ulterra. Instead, the Hex Head Bolts
(#2203431) and Clipped Washers (#2201725)
included in the mounting hardware that came with
the Ulterra motor should be used.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
e. Install the Top Plate Assembly to the motor using
three Hex Head Bolts (#2203431) and three
Clippeed Washers (#2201725). The Screws should
pass through the Clipped Washer and into the Top
Plate. Leave at least 1/4" space between the Hex
Head Bolt and Clipped Washer in order to slide
the Base Extrusion under the Clipped Washer and
into place.
7 | minnkotamotors.com
2b
Right Side Right Side
plate plate
3c
E-clip E-clip
Extension Extension
Damper Damper
3d
E-clips E-clips
4e
Clipped Clipped
Washer Washer
CAUTION
Use extra care to avoid pinching and damaging the sensor wires
that run along side of the Base Extrusion when installing and
tightening the motor mounting bolts.
2b
Left Sideplate Left Sideplate
E-clip E-clip
Mounting Hole Mounting Hole
Extension Extension
Damper Pins Damper Pins
Damper Damper
Hex Head Hex Head
Bolt Bolt
Top Plate Top Plate
©2020 Johnson Outdoors Marine Electronics, Inc.