MINN KOTA MKA-16-03 Instructions D'installation page 3

INSTALLATION
Installing the Top Plate to a PowerDrive or Terrova
1
a. Make sure that the Power Cables from the battery
are disconnected, or that the breaker,
if equipped, is "off."
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
2
b. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor should be in the stowed position.
c. Remove the four Sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
Deployed Deployed
3
d. Remove the Right Sideplate.
e. Swing the Left Sideplate out and away from the
Base Extrusion. Removing the sideplates exposes
the mounting holes in the Base Extrusion.
3d
Mounting Holes Mounting Holes
3 | minnkotamotors.com
Stowed Stowed
Right Sideplate Right Sideplate
Power Cables Power Cables
2c
NOTICE:
This motor weighs up to 65lbs. We recommend
having a second person help with the installation.
3e
Base Extrusion Base Extrusion
Sideplate Screw Sideplate Screw
Left Sideplate Left Sideplate
©2020 Johnson Outdoors Marine Electronics, Inc.