MINN KOTA MKA-16-03 Instructions D'installation page 8

5
f. Slide the Base Extrusion into place under the Bolts
that were just installed.
g. The Base Extrusion should slide between the Top
Plate and the Clipped Washers. Hold the Clipped
Washers up on the Stainless Steel Screw, so the
Clipped Washer will sit on top of the Base Extrusion.
6
CAUTION
Use extra care to avoid pinching and damaging
the sensor wires that run along side of the Base
Extrusion when installing and tightening the motor
mounting bolts.
h. Place the hardware on the Damper side of the
mount into the Mounting Holes to secure the
Base Extrusion.
i. Install the motor with the Hex Head Bolts
(#2203431) and Clipped Washers (#2201725).
Orientate the Clipped Washers so that the flat side
of the washer is towards the Base Extrusion. The
Bolt should pass through the Clipped Washer, Base
Extrusion and into the Top Plate.
7
j. At this point in the installation process, the Motor
should be secured to the Top Plate. The Motor can
now be reassembled. Slide the Extension Damper
back in place on the Damper Pins. This should
be done so the shaft on the Damper is pointing
inboard. Reinstall the two 5/16" E-clips.
8 | minnkotamotors.com
5g
Top Plate Top Plate
6h
Mounting Holes Mounting Holes
6i
Hex Head Bolt Hex Head Bolt
Clipped Clipped
Washer Washer
Mounting Mounting
Holes Holes
Top Plate Top Plate
E-clips E-clips
Power Tilt Power Tilt
Base Base
Clipped Clipped
Extrusion Extrusion
Washer Washer
Damper Pins Damper Pins
Extension Extension
Damper Damper
©2020 Johnson Outdoors Marine Electronics, Inc.