MINN KOTA MKA-16-03 Instructions D'installation page 5

6
k. After the Top Plate is secured to the Base Extrusion,
reassemble the Top Plate to the Bottom Plate
by sliding it in place and securing with the Lock
Washer and Tension Screw Knob.
l. Replace the Right Sideplate.
m. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
6l
n. Replace the four sideplate screws using a #3 or #2
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
Installing the Top Plate to a DeckHand 40
1
ITEM(S) NEEDED
a. Position the DeckHand 40 Davit and Base over the
Top Plate (Assembly #A) and mount the Bracket
using only the four holes that are farthest Outboard.
The two holes closest inboard are not used to install
the Bracket.
b. Take four Hex Head Cap Screws (Item #14) and
insert them from the bottom of the Outer Plate
through the DH40. Secure each Screw with a
Nylock Nut (Item #16). The Hex Head Cap Screws
should face inboard.
5 | minnkotamotors.com
Right Sideplate Right Sideplate
#A x 1
6m
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
6n
#14 x 4 #16 x 4
1a
Mounting Mounting
Holes Holes
Outboard Outboard
Inboard Inboard
Sideplate Screw Sideplate Screw
1b
Outboard Outboard
DeckHand 40 DeckHand 40 Nylock Nut Nylock Nut
Base and Davit Base and Davit
Outer Outer
Plate Plate
Hex Head Hex Head
Cap Screw Cap Screw
Inboard Inboard
©2020 Johnson Outdoors Marine Electronics, Inc.