Publicité
1
Getting Started
General Maintenance
Repair or service which are not covered in this manual should only be performed
NOTE
by qualified personnel.
To remove the dirt or moisture of the DAQ device, follow the instructions below.
1 Power off your DAQ device and remove the AC/DC adapter cord and I/O cable
2 Remove your DAQ device from its plastic casing by pulling at the bumper (front
3 Holding your DAQ device, shake out any dirt that may have accumulated on
4 Wipe your DAQ device with a dry cloth.
24
from your device.
end of the casing) in an outward direction. Then, lift the plastic body casing
and remove it from your DAQ device.
the panel of your DAQ device.
Keysight U2300A Series User's Guide
Publicité
