Publicité
Les langues disponibles
Les langues disponibles
T4
Short
Long press with
all loads off (mo-
tor and lights)
Remote-control activated
functions
Air Hub signals
Recommended device coupling sequence:
1 - Connected Mode (See remote control manual)
2 - Connected Mode Coupling (See hood manual)
3 - Remote Control-Hood Coupling (See remote control manual)
Warning:
If the following functions are present: Manual mode + Day mode are active and
the hood is turned on, the purifier turns off.
If the hood is on at any speed and the purifier is turned on, the hood turns off.
If the Night Mode function is active and the hood motor is turned on, the purifier turns
off. If the hood is turned off, the purifier turns on with the previously set function.
6. FRANKE@HOME APP
The Franke@Home App is available for
iOS and Android smartphones and al-
lows remote access to all hood func-
tions.
Manual mode
Turns on/off the UV-C lamp and ventilation at minimum speed. After
24 hours, the lamp and ventilation are turned off automatically.
Wi-Fi configuration
Activates/Deactivates the Wi-Fi set-up procedure.
Before starting the procedure, use the Franke@Home App to re-
gister with the Franke IOT system. Then follow the instructions to add
a new device and register the domestic router.
If the procedure is not successfully completed within a few minutes,
deactivate it by long pressing the key again, then make another at-
tempt. The hood will nonetheless abandon the procedure if it is not
successfully completed within 15 minutes.
Day mode
Turns on/off the UV-C lamp and ventilation at maximum speed.
After 2 hours, the lamp and ventilation are turned off automatically.
Night mode
Turns on/off the UV-C lamp and ventilation at minimum speed.
The automatic operating mode starts with a 24-hour work cycle in
which the device remains on for 5 hours and off for the next 19 hours.
After 7 days the night mode will be turned off automatically.
Lamp recommended replacement signal
After 6000h of operation, the signal is given to indicate replacement of
the lamp. To replace them, contact Technical Assistance.
Lamp broken signal
If the UV lamp burns out or does not turn on, the signal is given until
the lamp operation is restored. To replace them, contact Technical
Assistance.
Icon
Function
Home page
Add new device
LEDs T1 and T4 on.
LEDs T3 and T4 flash-
ing: configuration pro-
cedure in progress.
Upon successful com-
pletion of the procedure
LEDs T3 and T4 will
light up for 2 seconds.
LEDs T2 and T4 on.
LEDs T3 and T4 on.
LEDs T2 and T3 and
T4 flashing
LEDs T1 and T2 and
T3 and T4 flashing
15
Publicité
