Selve commeo Notice De Réglage page 29

Program/re-program radio
6.2. Re-program the sensor
Caution!
• The commeo Wind Sensor is programmed into the awning motor.
• A hand-held transmitter which is programmed into the awning motor or
Warning!
receiver is available.
• The hand-held transmitter is in operating mode. (please see operating
instructions of the hand-held transmitter).
Step 1
Push the PROG button of the hand-held transmitter for 3 seconds:
• Status LED flashes green for 2 seconds.
• The awning motor is ready to be programmed for 1 minute.
3 s
Step 2
Push the PROG button of the commeo Wind Sensor for 3 seconds:
• The commeo Wind Sensor is now re-programmed
• LED at the sensor flashes for 2 seconds, first orange, then red.
3 s
29
EN
EN