Horizon Global 76182 Instructions D'installation page 6

6. Trim heat shield – Using metal shears, trim the heat shield as
shown in figure 3.
8. Reinstall heat shield – Replace (2) of the (4) screws removed
previously. Do not replace the screws that go underneath the hitch bracket,
the hitch will sandwich the shield into place
©2021 Horizon Global Americas Inc. - Printed in Mexico
7. Install fasteners – Feed the coiled end of pull wire through the second
attachment hole and out of the forward most access hole in the bottom of
frame. Attach the 7/16" carriage bolt and 1/10" thick block (item 4) to the
pull wire and pull the fasteners into position, both sides. Repeat process
for all attachment points, both sides. Make sure the spacer blocks are
sitting flat inside the frame and do not overlap. See figure 2.
9. Install hitch – Raise hitch into position being careful not to push
fasteners back into the frame. Loosely install the conical washers (item 2)
and hex nuts (item 3) onto carriage bolts, (6) places.
Sheet 6 of 21 76182NP 06-07-21 Rev. B