Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Remove mud flaps – Using a flat head screwdriver, remove (1) rivet near wheel well liner and (1) rivet at the bottom on mud flap per side. Using a
Phillips screwdriver or 8 mm socket remove (2) screws on mud flap near wheel well liner per side. Remove the mud flaps and keep for reinstallation.
screws
Rivets
2. Remove rear fascia – Using a flat head screwdriver, remove (1) rivet on wheel wells and (3) rivets on the bottom of fascia per side. Open the hatch and
remove the (2) screws located near the brake light. Remove the fascia and trim fascia according to figure 4.
©2021 Horizon Global Americas Inc. - Printed in Mexico
Sheet 4 of 21
76182NP
06-07-21
Rev. B
Publicité
Table des Matières
