EWT Aqua Vac Aindus30 Mode D'emploi page 6

plugging into the power supply.(fig.4)
• Press the switch to 'On' (position 'I').(fig.5)
• After use, empty the tank and dry.(fig.6)
To vacuum large quantities of liquid, from a sink or
tank etc., do not immerse the nozzle completely
in the liquid, leave a gap at the top of the nozzle
opening to allow an air inflow. The machine is
fitted with a float valve which stops the suction
action when the tank has reached its maximum
capacity. The user will notice an increase in motor
speed. When this happens, turn off the machine,
disconnect from power supply, remove the
head from the container and empty the liquid
into a suitable receptacle or drain. To continue
vacuuming, refit the head and proceed. After wet
vacuuming, turn the machine off and remove
plug from power supply. Empty the container and
clean/dry the inside and outside before storage.
Remember! After wet vacuuming the foam filter
must be removed and the dust bag and cartridge
filter must be fitted before dry vacuuming again.
1
3
4
6
Maintenance
Make sure that the appliance is not plugged into
the power mains.Remove the suction hose from
the tank.Loosen the clamps and separate the
upper section from the tank (B3).Remove all the
dirt and residue from the tank and the hose.Clean
the foam plastic filter by washing it with a mild
detergent. Check the hoses and connections and
6
2
5
check the power cord for any damage.When the
foam plastic filter is removed, check the float . To
do this, take the upper section by the handle and
tip it carefully so that the filter basket is facing
upwards. The float should move freely up and
down.
2
1
4
5
Cartridge Filter Maintenance
WARNING! Always disconnect the plug from the
wall outlet before removing the tank cover.
NOTICE! This filter is made of high quality paper
designed to stop small particles of dust. The filter
should be used for dry pick-up. A dry filter is
necessary to pick up dust as when the filter is wet,
the filter will clog quickly and be very difficult be
cleanned.
Handle the filter carefully when removing it for
cleaning or when installing it. Check the filter
for tears or small holes as even a small hole can
let dust pass through and out of the cleaner.
Do not use a filter with holes or tears, replace it
immediately.
Installing &Cleaning
• Slide the cartridge filter down over filter
basket and push fully home.(fig.1&2)
• When removing the filter for cleaning hold the
cartridge filter to take off carefully to avoid
damage it.(fig.3 )
• Clean a dry filter by tapping it inside a waste
bin.(fig.4)
• Clean a wet filter by rinsing from the inside.
(fig.4)
• When wet the cartridge filter should be
removed and allowed to air dry for a 24 hours
3
6