Before Start-Up - Scheppach fs 850 Traduction Du Manuel Original

• Risk to health from running cutting disc due to long
hair and loose clothing. Wear personal protection
equipment like hair net and tight-fitting working clo-
thes.
• Even after taking all the necessary precautions, not
apparent residual risks cannot be ruled out completely.
• Residual risks can be minimized if the „safety inst-
ructions" and the „proper use", as well as operating
instructions manual are observed jointly.

Before start-up

Replace cracked diamond cutting discs.
• Get to know your machine. Familiarize yourself with
its use and its restrictions, but also with the specific
potential risks.
• Check the machine carefully for damages to ensure
that it is able to achieve the intended output. In case
of doubt, please replace the concerned component.
• Ensure that the switch is on Off, before inserting the
power plug into the mains socket.
• Ensure that the machine is cleaned and lubricated
properly.
• Before start-up, check the machine for damaged parts
and find out whether these parts are working properly
and performing their defined function.
• Check the alignment of all moving parts, all broken
or fastening parts, and all other conditions that can
affect smooth operation. Each damaged part should
be repaired or replaced by a technician immediately.
• Do not use the machine if a switch cannot be activa-
ted/deactivated correctly.
Operation
• Install the machine on an even, slide-proof floor.
• Check that the voltage on the nameplate matches the
existing voltage; connect the power plug to the mains
power supply only thereafter
• The cutting disc should be free to run before the ma-
chine is switched on.
Caution: Cutting disc must always be cooled with water.
Caution: Cutting disc runs with a time lag.
Do not break the cutting disc by applying pressure at the
sides.
• Under normal use conditions, the motor casing can
become hot.
• Do not use force on the machine or on an accessory
to achieve the performance of a bigger Industrial ma-
chine. It does a better job at the output for which it
is designed.
71