Clearing A User Code; Re-Initialising The Master Code And Relay Times - SOMFY VSYSTEMPRO Manuel D'installation Et D'utilisation

EN

3.5 Clearing a user code

It is possible to delete a user code without removing the rest of the parameter.
See diagram P4 at the end of the document.
Key:
Abbreviation
CM1
UN
Beeping sound
(*)
(2)
Note: It is possible to delete several user codes, one a er another.
Note: If the same user code is used for more than one usage number, it needs to be
deleted from all usage numbers so that it is not operational.

3.6 Re-initialising the master code and relay times

This procedure can be used in the event the master code is lost, for example.
A er this re-initialisation, the relay activation time returns to the factory setting, it
will be necessary to configure the relay time delays in accordance with the above-
mentioned connected equipment.
[1]. Switch off the power supply.
[2]. Keep "ENTER" pressed down and turn the mains power supply back on.
[3]. Release "ENTER".
The master code and relay time delays are in factory setting:
Default master code:
Default relay activation time
9
Meaning
Existing master code
Usage number: 2-digit number
The keypad emits a beeping sound instead of a little tune to indicate
an input error (a single digit for example): in this instance, the
correct parameter needs to be entered again in order to be able to
continue the procedure.
At this stage, the user code matches a usage number that has been
entered and cleared. It is then possible to enter another user code
or to exit the procedure.
11111111
4 seconds
Copyright © 2016 Somfy SAS. All rights reserved.