ABB 6597 Serie Mode D'emploi page 63

GB
Modes of operation
5.7 Cleaning light
This mode of operation is activated via an external
conventional switch (Fig. 1, Pos. ); channels D1 and D2
are set to a brightness level. The brightness level depends
on the setting on the coding switch.
• Push pin on the coding switch to "on" to enable an
increased brightness level.
NOTE
Other pushbutton and analog signals are ignored.
5.8 Analog operation with a switch
In order to separate switching/dimming from operator
input in analog operation, the switch on pin must be set
to "on".
The condition for this mode of operation is that a switch
(e.g. a time switch) has been connected to pushbutton
input T1, which then assumes the switching function.
63