ABB 6597 Serie Mode D'emploi page 62

Modes of operation
5.6 "Vacation"
The 6597-.../STD-SBS control module automatically stores
output states for each channel (D1/ D2) at intervals of 6
minutes. These are overwritten after 24 hours, starting
with the "oldest" value. These stored values have no effect
in the "off" position.
• Push pin
The stored signals are automatically repeated in a 24
hour cycle.
NOTE
Operation via pushbutton is possible in this mode of
operation. The vacation function is interrupted and
continued only after switch-off by the pushbuttons.
After a power failure, a time-shift of the "vacation data"
may occur.
on the coding switch to "on".
GB
62