Pentair Water Pool and Spa Legend Manuel D'installation page 9

PUSH MIDDLE OF OPEN
THE BAG INWARD
FOR CLOSURE
CLEANER BAG
Figure 14
SNAP TOGETHER
"U" SHAPED
SNAP LOCK
CLOSURE
CLEANER BAG
Figure 15
Periodic Maintenance
The following parts are wear items that should be checked, maintained or replaced as needed. Wear items are considered any
working or moving part(s) being worn due to the use of the cleaner.
Wear items are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a secondary filter. This screen is to keep debris that is passed by the pool filter
out of the Legend ® . Running the Cleaner without the filter screen can damage the Legend
A continuous plugged or dirty screen is a sign of problems in your pool filtration system and you need to contact your local Pool
Professional.
WALL FITTING
FILTER SCREEN
SEAT
FILTER SCREEN
Figure 16
9
"U" SHAPED SNAP
LOCK CLOSURE
CLOSE
CLIP
FEED HOSE
MENDER NUT
To close, push the middle of bag inward, as shown, and bring the
edges together to make them stack like an accordion. Swing the
"U" shaped snap lock closure back to the closing position.
Gently push on top of the "U" shaped snap lock closure to make
sure it snaps into place. Reattach the clip onto the feed hose.
Your debris bag is ready to be reinstalled onto your cleaner.
If you have a lot of debris in your pool, especially after a storm,
®
you can run your Legend in two shorter cycles per day and
empty the debris bag between cycles.
Reconnect the debris bag to the vacuum tube. Do NOT over turn.
A Helpful Hint: It is easier to empty the debris bag when it is dry.
A second bag may be used while the full debris bag is drying.
It's best to empty the debris bag when it becomes half full.
The Legend ® will have better performance if the bag is not
overloaded
® and will void the warranty.
To clean the filter screen, pull the screen out from inside the
Wall Fitting and rinse thoroughly and push back inside the Wall
Fitting.
Whenever cleaning, back-washing or repairing the filter, remove
the Wall Fitting and flush out the dedicated line before using the
Legend ® .
Operation/Periodic Maintenance