Fine Tuning The Legend; Operation/Periodic Maintenance; Connecting/Disconnecting The Legend; Turning On/Off The Legend - Pentair Water Pool and Spa Legend Manuel D'installation

Fine Tuning the Legend

TURNS LEGEND
LEFT
Figure 12
3. Checking Wheel RPM
To determine whether the Legend
water pressure, turn off the pool pump, and carefully remove
the Legend ® from the pool.
Mark the front drive Tire/Wheel with a marker, or use the
Pentair logo located on the side of tire as a marker to count
the rotations of the wheel per minute.
Have someone turn on pool pump and the booster pump
while you place the Legend
water surface. (Be sure to hold onto the Sweep Hose to
avoid getting wet).
Count the rotations of the marked wheel for exactly one
minute. (Be sure the Back-Up Valve isn't cycling at this
time). The rotations will give you the Revolutions Per Minute.
(RPM)
For proper performance, the Legend
28-32 RPM. If the RPM is below 28 then call your local Pool
Professional.
If the RPM is more than 32, at the Wall Fitting, unscrew the
Pressure Relief Valve slowly until the RPM falls between
28-32.

Connecting/Disconnecting the Legend

Turn off the booster pump and pool pump. Then take the Wall Fitting and twist lock the Wall Fitting clockwise into the Wall Adapter.
To disconnect the Legend

Turning On/Off the Legend

The Legend ® operates off the booster pump coming from the equipment pad, and can be turned on or off by merely turning on/off
your booster pump time clock.
Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum tube. Use your thumb to push the "U" shaped snap lock closure upward until it
snaps open. Make sure to swing it away from the opening. Open the bag and remove debris.

Operation/Periodic Maintenance

®
LIFTS FRONT
UP
TURNS LEGEND
RIGHT
PUSHES FRONT
DOWN
® is receiving the proper
® in the pool just beneath the
® operates between
®
, unlock and twist counter-clockwise. The Wall Adapter should remain in the pool wall.
®
1. Thrust Jet Adjustment
There is a Thrust Jet located in the back of the Legend
This Thrust Jet alters the direction of the cleaner. The factory
standard position for the jet is set in the middle and straight
out.
(See Figure 12)
2. Sweep Hose Adjustment
The Sweep Hose operates in a gentle sweeping motion. To
increase or decrease the motion of the Sweep Hose, adjust
the screw which is located on the Feed Mast Barb below the
Ballast Float. Turning the screw clockwise will decrease the
motion and counter-clockwise to increase the motion of the
Sweep Hose.
SWEEP HOSE
FRONT WHEEL
DRIVE
Figure 13
Operation/Periodic Maintenance
®
®
.
Section 3:
8