Pentair Water Pool and Spa Legend Manuel D'installation page 6

EXAMPLE OF FINISHED HOSE
ASSEMBLY AFTER CUTTING TO
LENGTH
MARKED SWIVEL
Figure 6
Cutting the Feed Hose - (cont.)
3. Lay the telepole next to the clear (soft) hose. If the
clear (soft) hose is longer than the mark on the
telepole, cut the excess from the end attached to the
white (hard) hose. Do not cut off the float.
Leave the first float in position next to the Back-Up
Valve. Place the second float midway between the first
float and the Hose Swivel.
MENDER NUT
FEED HOSE
STEP 1
PUSH HOSE OVER BARB
STEP 2
PUSH MENDER NUT TOWARD HOSE AND ROTATE CLOCKWISE
BY HAND UNTIL TIGHT
STEP 3
Figure 8
Installation Instructions
STEPS
4. Reassemble the hoses using the supplied mender nuts as shown in FIGURE 6.1.
5. Your complete nished hose assembly should look like this. The end of the 75 cm
clear hose should reach just to the furthest edge of the pool perimeter as shown.
WHITE OR GREY
HARD HOSE SECTION
WHITE OR GREY HARD
HOSE SECTION
SOFT HOSE
(Out to your pool depth)
BACK UP VALVE
BARB ON
SWIVEL OR
LEGEND
SMALL END OF
MENDER NUT
AWAY FROM HOSE
WHITE OR GREY
HARD HOSE
SECTION
(WALL FITTING
SIDE)
MARKED SWIVEL
END OF SOFT HOSE
(End remains 75 cm.)
FUETHEST POINT OF POOL PERIMETER
FROM WALL FITTING
TELEPOLE / CLEAR (SOFT) HOSE
WHITE (HARD) HOSES
SWIVEL
CUT AND REMOVE THE EXCESS
HOSE LENGHT
Figure 7
4. Attach feed hose to the wall fitting and attach wall fitting
to the pool wall. Hold the end of clear (soft) hose and
walk the perimeter of the pool keeping the hose straight
(do not stretch hose) to find the farthest point of the pool
from the wall fitting.
5. Measure the excess length between the farthest point
of the pool from Wall Fitting and the end of 75 cm clear
(soft) hose.
6. Half of this measured length is to be cut equally from
3 m. white (hard) hoses next to the Marked Swivel.
(Example: Half of 180 cm. = 90 cm. each). If you are
cutting more than 60 cm. off the hoses, remove the floats
next to the Marked Swivel from both hoses. See figures 5
and 6.
7. Re-assemble the hoses and the swivel using mender
nuts, see the figure 8. Put mender nut on swivels first,
then push hose over swivel, rotate mender nut over
hose clockwise until tight. Note: Keep as many floats as
possible on white feed hoses spaced evenly apart to hold
hose up on top of water.
8. When cutting hoses, please use strong scissors or a
sharp knife. Be sure to slide the floats out of the way
when cutting hose.
9. Put extra mender nut on the Legend
clear (soft) hose gently over mast at 1/2", turn mender nut
around clear (soft) hose tight. Note: The Back-Up Valve
still should be 30" from the head of the cleaner.
WHITE OR GREY
HARD HOSE
SECTION
(CLEANER SIDE)
Figure 6.1
WATER LEVEL
CUT CLEAR (SOFT) HOSE EQUAL TO
THE DEEPEST POOL WATER LEVEL
® mast and push
6