Rowenta ES440010 Mode D'emploi page 11

IFU_RO_PERFECTO_4400_NC00025894-01_eo 27/09/11 11:26 Page11
Problems
The cups are not filled
equally.
The espresso leaks from
the sides of the filter
holder.
Your espresso has a bad
taste.
The pump is not
operating
The steam nozzle does
not froth the milk.
If the cause of the problem cannot be determined, contact an approved service centre. Do not
dismantle the appliance yourself! (If dismantled, this will invalidate the guarantee).
13. ELECTRICAL OR ELECTRONIC PRODUCT TO BE DISPOSED OF
Do your part to protect the environment!
HELPLINE:
If you have any product problems or queries, please contact our Customer Relations Team first
for expert help and advice:
0845 602 1454 - UK
(01) 677 4003 - ROI
or consult our website - www.rowenta.co.uk
Possible causes
The filter holder is dirty.
The filter holder is not fitted
correctly.
The edge of the filter holder has
coffee on it.
After descaling, the appliance has
not been rinsed correctly.
The pump has been drained due
to lack of water.
The removable water tank is not
fitted correctly.
The steam nozzle is blocked or
scaled.
The milk is too warm or not fresh.
The container is not the right
shape.
Your appliance contains many materials that may be recovered or recycled.
Please take it to a local civic waste collection point
Refer to paragraph 9.B for the
maintenance of the filter holder.
Fit the filter holder in place and lock it
(turn it from left to right as far as
possible) (fig. 3).
Remove the excess coffee (fig. 10b) and
clean the water grill with a damp
sponge.
Rinse the appliance according to the
instructions (paragraph 9) and check
the quality of coffee.
Fill the water tank and restart the pump
(see paragraph 5. "FIRST USE"). Avoid
emptying the water tank completely.
Push the water tank firmly to fit it
correctly.
Descale the steam nozzle as described
in the paragraph "DESCALING" or
unblock it with a needle.
Use very cold, very fresh milk.
Use a small jug.
11
Solutions
EN