Sauder Utility Stand 409944 Instructions D'assemblage page 14

Step 9
Carefully turn your unit over onto its front edges. Lay the
å
BACK (D) over your unit.
Make equal margins along the two long and two short
å
edges of the BACK (D). Push on opposite corners of your
unit if needed to make it "square".
Fasten the BACK (D) to your unit using the NAILS (JJ).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Fasten the LEFT REAR LEG (I) to the TOP (C). Tighten the
å
HIDDEN CAM.
Maximum
210 degrees
Minimum
190 degrees
Page 14
D
Arrow
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(20 used in this step)
C
I
409944
JJ
NAIL
Tighten this HIDDEN CAM.
www.sauder.com/services