Safety Instructions - FT Technologies Acu-Res FT722 Manuel De L'utilisateur

•
To ensure the safe installation and operation of this product the equipment must be installed and
integrated:
o
Using suitably qualified and trained personnel
o
In accordance with any regional electrical codes
o
In accordance with the instructions set out in this manual, observing all information, warnings
and instructions
o
In accordance with any other instructions or guidance FT Technologies provide
•
To ensure that the product remains compliant with the electrical safety requirements of the UL / CSA
61010-1 Standards it must be;
o
Connected to a regionally approved limited PSU rated 12-30VDC (current limited 6A maximum)
o
Protected by UL 1449 listed surge protection devices
o
Connected with an approved interface cable (for example UL/ CSA recognised AWM style
21198, rated 300V, 80°C)
•
The equipment must only be operated within the range of the specified technical data and used for the
purposes for which it was designed.
•
The equipment should always be transported in packaging which is appropriate, that will prevent any
accidental damage from occurring.
•
Always ensure that any failures or errors from the product cannot cause any damage to any other
equipment or property or cause any other consequential effects.
FT722 et FT742 (RS-485) – Capteurs FF et PM – Manuel de l'utilisateur
6

Safety Instructions

English
Section 1 Introduction