Allmatic PROXIMA S Mode D'emploi page 3

Control unit for one motor roller shutters
ATTENTION: DO NOT INSTALL THE CONTROL UNIT BEFORE
1. Introduction.
The PROXIMA S control unit is suitable to operate roller shutters and sunshades. This device houses a radio receiver for remote controlling through
transmitters of the B.RO series (Fig. 1) and CLARUS series (Fig. 2). In order to simplify the installation, the power supply is the 230V ac mains supply
and, by means of three cables, it is possible to connect motors with power up to 500W with internal limit switches. It is possible to connect to
PROXIMA S control unit two buttons for opening and closing functions.
2. Configuration.
Learn Button
Radio module
Command connection terminal board
3. Electrical connections
4. Learning operations
4.1 Learning of the first transmitter
When the system is supplied with power, the control unit enters automatically the learning mode, waiting for the command signal of a transmitter.
When the button of a transmitter is pressed, the control units memorizes the channel buttons and exits the learning mode. At the next start the
control unit emits two beeps (by means of the buzzer, if present on the card), indicating that at least one channel of a transmitter has been
memorized.
4.2 Learning of next transmitters by means of the LEARN button
a b
a
a b
1 1
c
b
4.3 Learning of next transmitters by means of a previously learnt transmitter
1) Opening memory: To open memory from the transmitter, please refer to the user's guide of the transmitter itself. When memory of the control unit
is open, this emits a sequence of beeps (through the buzzer, if present on the card) to indicate that it is entering the learning mode.
2) Press the "a" or "a1" button of the transmitter. The control unit memorizes automatically also the "b" or "b1" button and the "c" button for the
CLARUS series ("a" or "a1" as the "open" button, "b" or "b1" as the "close" button and "c" as the "stop" button). The memorization of the channel is
indicated (through the buzzer, if present on the card) by two long beeps if the channel had not been previously learnt and one beep if it had been
previously learnt. When channel is memorized, the control unit goes back to the normal operation mode. If no signal is transmitted within ten seconds,
the control units exits automatically the learning mode.
6-1622134 rev.3 12/12/2022
PROXIMA S Control unit
READING THE INSTRUCTIONS!
Transformer
J1 J2
Buzzer and Jumper
(if present)
LEARNING:
1) Press the LEARN button on the control unit. The unit emits a sequence of beeps (by means of the buzzer, if
present on the card).
2) Press the "a" or "a1" button of the transmitter. The control unit memorizes automatically also the "b" or "b1"
button and the "c" button for the CLARUS series ("a" or "a1" as the "open" button, "b" or "b1" as the "close"
button and "c" as the "stop" button). The memorization of the channel is indicated (through the buzzer, if
present on the card) by two long beeps if the channel had not been previously learnt and one beep if it had
been previously learnt. When channel is memorized, the control unit goes back to the normal operation mode. If
no signal is transmitted within ten seconds, the control units exits automatically the learning mode.
ITA ENG FRA ESP DEU POR
Fig.1 Fig.2
Tx series B.ro Tx series CLARUS
1/2