Table des Matières
Publicité
SM 2610012178 07-10:2610007743 07-09 3315 7/8/10 1:55 PM Page 26
Installation of miter lock Knob
1.
Carefully thread the miter lock knob 1 into the hole 2
located at the front of the miter table (Figure 2).
2.
Turn the miter lock knob clockwise to tighten. Do Not
Over Tighten.
3.
Loosen handle 1/4 turn or more and press down on the
miter handle release 3 to unlock the miter table from the
set position. To lock, tighten the handle.
Installation of Bevel lock Knob
1.
Place the washer 1 over the threaded bolt 2 attached to
the bevel knob 3 (Figure 3).
2.
Insert the bolt into the opening 4 at the rear of the saw.
3.
Turn the knob clockwise to tighten. Do not over tighten.
Store the Saw Blade wrench
Store the blade wrench 5 in the clip at the rear of the saw base
to prevent loss (Figure 3).
Assembly
1
4
2
3
26
FIG. 2
3
1
2
FIG. 3
3
Publicité
Table des Matières
