WMF 3 Mode D'emploi page 6

Removing the toast
·
Browning level
·
·
·
STOP
Cancelling the toasting process
·
Reheating / Retoasting
·
Defrosting
·
Bread roll holder
·
·
Crumb tray
·
10
Pushing the loading handle upwards will raise the bread lift
and make it easier to remove the toast.
If the toast is too light in colour, select a higher browning
level. If the toast is too dark, set the slide control for the
browning degree to a lower level. The figures 1 to 7 are for
guidance purposes only. The higher the selected level, the
browner the toast.
The toasting results may vary depending on the type of
bread, size, moisture content and thickness of the slices.
Therefore, select a lower setting for less moist bread, for
smaller slices, or if only toasting one slice.
When toasting only one slice, the browning on the inwards
facing side will become somewhat darker.
Acrylamide is generated during excessive browning. Exces-
sive browning of the toast should therefore be avoided.
Press the illuminated button to cancel the toasting process
prematurely.
If the reheating button is pressed directly after the appli-
ance is switched on, toast that has already cooled down
will be made warm and crisp independent of the selected
browning level and bread which is too light in colour will be
retoasted.
If this button is pressed directly after the appliance is swit-
ched on, the toasting cycle will be extended automatically
to toast frozen bread.
The toaster is supplied with an integrated bread roll holder.
It is set up by turning the control knob in clockwise direc-
tion.
Two bread rolls can be made warm and crisp from both
sides, each at a medium setting level. Bread rolls which are
too dry can be moistened slightly to achieve better results.
Crumbs which drop during the toasting process will collect
in the crumb tray. Pull the crumb tray out of the appliance
for emptying.
Cleaning and service
· Before cleaning, disconnect the appliance from the mains
and allow it to cool down. Use a hard brush to remove
crumbs sticking to the grids and the heater. Do not tilt the
appliance while you do this, or crumbs will spill from the
crumb tray into the inside of the toaster. Then pull out the
crumb tray, clean it and reinsert.
· Never immerse the toaster in water. Clean the exterior only
with a damp cloth and a little washing-up liquid. Do not
use harsh or abrasive cleaning agents.
For UK use only
· This product is supplied with a 13 A plug conforming to BS
1363 fitted to the mains lead. If the plug is unsuitable for
your socket outlets or needs to be replaced, please note the
following. If the plug is a non-rewireable one, cut it from
the mains lead and immediately dispose of it. Never insert
it into a socket outlet as there is a very great risk of an
electric shock.
· The replacement of the plug at the mains lead has to be
done according to the following instructions:
Warning - This appliance must be earthed
· Important: The wires in this mains lead are coloured in
accordance with the following code:
· green/yellow Earth
· blue Neutral
· brown Live
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
· the wire which is coloured green and yellow must be
connected to the terminal which is marked with the letter
E or by the earth symbol or coloured green or green and
yellow,
· the wire which is coloured blue must be connected to the
terminal which is marked the letter N or coloured black,
· the wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
· If a 13 A (BS 1363) plug is used it must be fitted with a 13
A fuse conforming to BS 1362 and be ASTA approved. If any
other type of plug is used, the appliance must be protected
by a 10 A fuse either in the plug or adapter or at the
distribution board.
If in doubt - consult a qualified electrician.
· Never use the plug without closing the fuse cover.
11