Petsafe Deluxe Remote Trainer Mode D'emploi page 4

Install The Batteries in the Receiver
The receiver takes two (2) 3-Volt Lithium batteries (Model 2032).
To install, follow the instructions listed below:
• With a Philips screwdriver,
remove the two screws located
on top of the receiver.
• Remove the battery door by sliding
the door up in the direction of the
arrows before sliding the door out.
Insert the two batteries into the battery
door as shown in the drawing.
• Insert battery door with batteries in
place by pushing the door in and then sliding it down in the opposite direction of
the arrows. Secure it with the two screws. Be sure to tighten the screws without
over tightening.
Turning the Deluxe Remote Trainer On/Off
To turn the receiver on, place the white dot on the transmitter unit against the white
dot of the receiver unit, hold them together for three (3) seconds, and separate. Upon
separating, the receiver will emit one short beep.
Note: If receiver does not beep, battery needs replacement. You can expect
a fresh battery to last about 4 months with average use.
Note: Once the receiver has been activated, the receiver must be manually
turned off by following the instructions shown below.
To turn the receiver off, place the white dot on the transmitter unit
against the white dot of the receiver unit, hold them together for three (3)
seconds, and
separate. Upon
separating, the
receiver will emit
a long beep
indicating the
unit has been
turned off.
4
Deluxe Little Dog Trainer Deluxe Big Dog Trainer
Positive " + " is up, negative " - " is down.