Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
– Repeat of the current title
indication REP
– Replay of the titles in a random order
indication: A
– No repeat function
indications REP and A extinguished
3 Button SD / USB to switch over between USB
memory stick and SD / MMC card
4 Volume controls MIC 1 and MIC 2 for micro-
phones connected to the jacks below
5 Volume control AUX / PHONO for a unit con-
nected to the jacks AUX / PHONO (23)
6 Power indication
7 USB jack for inserting a USB memory stick
8 Slot for an SD / MMC memory card (max. 32 GB)
When inserting the card, the bevelled edge
must point to the right and to the unit. To remove
the card, slightly press it into the slot so that it
disengages.
9 Buttons
and
next title
10 Buttons VOL+ and VOL- for the volume of the
MP3 player
11 Button
to change between reproduction and
pause
12 Button
to switch the MP3 player on and off
(keep the button pressed until the display lights
up or extinguishes) and to stop the playing
(shortly press the button)
13 Jacks MIC 1 and MIC 2 (6.3 mm jack, unbal.) for
connection of microphones
The input MIC 1 has an automatic talkover func-
tion (see chapter 2)
14 Tone control
15 POWER switch
Notes: After switching-on, the MP3 player starts
automatically when a USB memory stick or an
SD / MMC card is inserted.
For 12 V operation via the connections DC IN -
PUT (19) the switch has no function.

4.2 Rear panel

16 Mains jack for connection to a socket (230 V~/
50 Hz) via the mains cable provided
17 Support for the mains fuse
Always replace a blown fuse by one of the same
type
18 Ground connection, e. g. for a turntable
19 Terminals DC INPUT for 12 V operation or for a
12 V emergency power supply
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
1
to select the previous or the
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
20 Speaker connections
Either connect 100 V speakers to the terminals
"100 V" and "COM" (fig. 3a); the amplifier may
be loaded by the speakers with 15 W RMS as a
maximum, otherwise it may be damaged
or connect a speaker or a speaker group with a
total impedance of 4, 8 or 16 Ω as a minimum to
the terminals "4 Ω", "8 Ω" or "16 Ω" and "COM".
Fig. 3b shows various ways to keep the mini-
mum impedance. However, there are also other
possibilities.
21 Cover for the terminals
WARNING Never operate the amplifier with-
out cover. Otherwise you will risk
an electric shock when touching
the terminals.
22 Feed-through connections PRE OUT and AMP
IN for external sound effect, e. g. by an equalizer
Connect the input e. g. of the equalizer to the jack
PRE OUT and the output to the jack AMP IN.
Note: The amplifier does not give any signal
when the unit inserted is switched off, if it is
defective or not correctly connected. When no
unit has been connected, the jumper must be
connected to the jacks.
23 RCA jacks for connection of a unit with line out-
put (CD player, radio, tape deck) or a turntable
24 Selector switch for the input AUX / PHONO (22):
Position AUX for a unit with line output
Position PHONO for a turntable
5 Specifications
RMS output power: . . . . . . 15 W
THD: . . . . . . . . . . . . . . . . . < 1 %
Frequency range: . . . . . . . 80 – 18 000 Hz, ±3 dB
Input sensitivity of the audio inputs
MIC 1 and MIC 2: . . . . . . 3 mV
AUX / PHONO: . . . . . . . . 500 mV/ 3 mV (RIAA),
Speaker outputs: . . . . . . . . 4 Ω, 8 Ω, 16 Ω, 100 V
S / N ratio
MIC 1 and MIC 2: . . . . . . > 65 dB
AUX: . . . . . . . . . . . . . . . > 75 dB
PHONO: . . . . . . . . . . . . > 55 dB
Ambient temperature: . . . . 0 – 40 °C
Power supply
Mains voltage: . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . max. 60 VA
DC power supply: . . . . . 12 V , max. 2 A
Dimensions: . . . . . . . . . . . 240 × 75 × 230 mm
Weight: . . . . . . . . . . . . . . . 3.2 kg
Subject to technical modifications.
switchable
GB
7

Publicité

Table des Matières
loading

Table des Matières