Extra Information; Troubleshooting - Inventum IKI3008 Manuel D'utilisation

1. Lock the appliance.
2. Remove food stains. Use a damp cloth and a mild cleaning agent.
3. Clean the appliance daily. Use a damp cloth and a mild cleaning agent.
4. Dry the appliance. Use paper towels or a dry tea towel.
5. In case of heavy dirt, clean the appliance with a special cleaning agent suitable for an induction appliance.
6. In case of spillovers on the controls, the appliance may beep and turn itself off. Soak up the spill and dry the area
before turning the appliance back on.
7

Extra information

REQUIREMENTS FOR PANS
Note:
Pans that were previously used on a different appliance (for example a gas appliance) are no longer
suitable for an induction appliance.
(Figure 3)
• Use pans with a thick and flat bottom. The diameter of the pan must be the same as the diameter of the cooking
zone.
• Use pans made from metal, enamelled metal, cast iron or stainless steel. These pans give the best result.
• Obey the instructions from the manufacturer of the pan to see if the pan is suitable for an induction appliance.
• Pans made from metal or aluminium pans with a copper bottom may stain the glass plate. Remove the possible
stains immediately after using the appliance.
• Use a magnet to check if a pan is suitable for an induction appliance. The pan is suitable if the magnet sticks to
the bottom of the pan.
• Make sure that you put the pan in the center of the cooking zone.
• Some pans may produce sounds during use. The sounds are caused by the shape of the pan. This does not
affect the operation or safety of the appliance.
• Never slide pans over the appliance, always lift the pans to avoid scratching the glass.
POWER LEVELS FOR COOKING
Note:
The values are indicative.
Power level Usage
0 Cooking zone is switched off.
1-2 Low simmer and slow heating.
3-4 Heating and quickly bringing to a simmer.
5-6 Medium cooking.
7-8 Cooking and roasting.
9/p Searing, stir-frying and bringing to the boil.
8

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the breakdown codes.
2. If you cannot find a solution for the problem or the breakdown code keeps re-occuring, contact Inventum-
servicedienst
English • 35