Lamborghini Caloreclima REMOTO CRM N Manuel De L'utilisateur page 138

4.7 Installation
The Remote Control must be secured to the wall, at about 1.5 m above the floor, in a place away from entrance doors, windows
or heat sources that can affect the room temperature. Before installing, disconnect the power to the boiler. Remove the front
part of the Remote Control by prising with a screwdriver at points A. Then secure the back of the Remote Control to the wall
with the set of fastening screws provided, making sure to run the 2 wires inside the holes located above the terminals. Use the
"COM" terminals for the electrical connection. If the telephone contact (voltage-free contact) has to be connected, use the "AUX"
terminals. Reinsert the front part of the Remote Control
A
C O M
A U X
A
Use a bipolar cable (2x0.75mm2, max 2x2.5mm2) making sure its path is not the same as that of the mains power cables. The
maximum cable length must not exceed 50m.
EN
138
code 3541Z230 - Rev. 05 - 12/2021