Lamborghini Caloreclima REMOTO CRM N Manuel De L'utilisateur page 132

3.7 System filling
This function manages the operation mode of the electric device for filling the water circuit in certain boiler models.
1. Press the button
2. The display shows parameter CU.
3. Press the button
Set to 0 using the buttons
manual system filling. Set to 2 using the buttons
4. Press any other button to exit the menu.
Attention: Set manual filling on the boiler control board. In manual operation and if the sensor installed in the boiler detects
insufficient pressure, the bar icon will blink on the display; pressing the button
During manual or automatic system loading, the bar icon will become steady. Once the nominal pressure has been re-established,
the remote control will return to the normal display.
3.8 Temperature unit of measure selection
Follow the instructions below to use the Remote Control in °C or in °F.
1. Press the button
2. The display shows parameter CU.
3. Press the button
Set to 0 using the buttons
Set to 1 using the buttons
4. Press any other button to exit the menu.
EN
132
for 3 seconds.
repeatedly until parameter P5 is displayed.
/ to deactivate the electric filling device. Set to 1 using the buttons
for 3 seconds.
repeatedly until parameter P6 is displayed.
/ to select °C.
/ to select °F.
code 3541Z230 - Rev. 05 - 12/2021
/ to activate automatic system filling.
/
will activate the special solenoid valve.
to activate