Lamborghini Caloreclima REMOTO CRM N Manuel De L'utilisateur page 129

Les langues disponibles

Sliding temperature - Compensation according to room temperature.

As the room temperature approaches the set point, the temperature of the heating system is further adjusted in order to reach

the desired value as precisely as possible, without excess heat and wasted energy, thereby significantly improving user comfort.

3.3 Enable DHW programming

Follow the instructions below to enable DHW programming.

1. Press the button

2. The display shows parameter CU.

3. Press the button

Set the desired value using the buttons

0 = Program disabled, continuous comfort both in summer and winter.

1 = Program enabled only in winter

2 = Program enabled in summer and winter

3 = Program disabled, continuous economy both in summer and winter

4. Press any other button to exit the menu.

_________________________________________________________________________________________________________________________________________________

To set the automatic weekly program, proceed as described in par. "Phase2. Setting the automatic weekly program", selecting the

faucet symbol at point "1" and considering that at point "3" EC (Economy) or CO (Comfort) will be set instead of a temperature

value. In fact, the remote control has a weekly time programmer based on two levels: during COMFORT level the boiler will

keep storage at the set temperature; during the Economy level the boiler will not deliver domestic hot water. Regarding the type

of storage, refer to the boiler documentation.

Attention: Make sure the remote control is switched to Winter mode and automatic operation.

for 3 seconds.

until parameter P1 is displayed.

code 3541Z230 - Rev. 05 - 12/2021

129