GENERal SaFEty INStRUCtIONS (CONtINUED)
•
Do not operate the equipment with the control panel door open, the
electrical system energized and live parts exposed.
•
Disconnect the dryer from the electrical supply when any electrical
work is performed. Lock out the safety disconnect and obtain any
required work permits.
The desiccants used in this equipment are not considered hazardous.
However all contact with or disposal of the desiccant should be in
accordance with the relevant MSDS. The following lists the more common
safety measures normally observed during filling operations.
•
In the case of accidental contact of the desiccant with the eyes, rinse
immediately with an abundance of clean water. Refer to the MSDS.
•
Accidental spillage of desiccant on the floor should be cleaned up
avoiding the creation of excess dust during this procedure.
•
Use a contoured face mask during any filling or draining operations.
Refer to the MSDS.
In designing this unit a lot of care has been devoted to the protection of the
environment:
•
Dryer and relevant packaging composed of recyclable materials.
•
Energy saving design.
pressure. Never point the compressed air or the condensate drain jet
towards anybody.
This user is responsible for the installation of the dryer, which has to
be executed on the basis of the instructions given (see Installation
Instructions). Otherwise, the warranty will be voided and dangerous
situations for the personnel and/or damages to the machine could occur.
Only qualified personnel can use and service electrically powered devices.
Before attempting any maintenance action, the following conditions must
be satisfied:
•
Ensure that any part of the machine is under voltage and that it can
not be connected to the mains.
•
Ensure that any part of the dryer is under pressure and that it cannot
be connected to the compressed air system.
and authorized by the Manufacturer, in addition to create the
possibility of dangerous conditions it will void the warranty.
2
Maintenance and/or control operation to be very
carefully performed by qualified personnel.
Compressed air is a highly hazardous energy
source. Never work on the dryer with parts under
Any change to the machine or to the relevant
operating parameters, if not previously verified
Don't use water to extinguish fire on the dryer
or in the surrounding area.