Installation Instructions - Speedaire 53RG60 Manuel D'utilisation

INStallatION INStRUCtIONS

proper Use of the Dryer
This dryer has been designed, manufactured and tested only to be used to
separate the humidity normally contained in compressed air. Any other use
has to be considered improper. The Manufacturer will not be responsible
for any problem arising from improper use; the user will be in any case
responsible for any resulting damage.
Moreover, the correct use requires the compliance with the installation
conditions, in particular:
• Voltage and frequency of the primary electrical supply.
• Pressure, temperature and flow rate of the incoming air.
• Ambient temperature.
This dryer is supplied tested and fully assembled. The only operation left
to the user is the installation of the desiccant into the dryer towers and
the connection to the plant in compliance with the instructions given in the
following chapters.
The purpose of the machine is the separation of water present in
compressed air. The dried air cannot be used for respiration purposes or
for operations leading to direct contact with foodstuf, unless subject to
further treatments.
Instructions for the Use of pressure Equipment
To ensure the safe operation of pressure equipments, the user must
conform strictly to the following:
1. The equipment must only be operated within the temperature and
pressure limits stated on the manufacturers name/data plate.
2. No welding is allowed on the shell and end caps.
3. The equipment must not be stored in badly ventilated spaces, near a
heat source or inflammable substances.
4. Vibration must be eliminated from the equipment to prevent fatigue
failure.
5. An internal inspection must be carried out at 12 month intervals to
check for pressure equipment corrosion. The actual wall thickness of
the tower after corrosion should not be less than the data indicated on
the chart located on the side on the tower.
6. Condensate drains should be checked for operation every day to
prevent a build up of condensate in the pressure equipment.
7. The maximum working pressure stated on the manufacturers data
plate must not be exceeded.
8. All documentation supplied with the equipment (manual, declaration of
conformity etc.) must be kept for future reference.
9