Wet Pick Up Operation - Shop-Vac CH87 Serie Manuel D'utilisation

INSTALLING THE DISPOSABLE FILTER BAG:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
22. Use the disposable filter bag in conjunction with the
cartridge filter for easy disposal of the debris. The bag
is not required for normal dry pick up. When picking up
fine dust or powders a high efficiency filter bag (not
standard with all models) must be used.
NOTE: Use for dry pick up only.
23. With cord disconnected from the receptacle, pull
latches in an outward motion and remove the tank
cover.
24. Unscrew hose locking-nut and
remove hose from inlet.
FIGURE 15.
FIGURE 15
25. Remove the inlet defector from
the deflector guide. NOTE: Hose
must be removed before the inlet
deflector can be taken out.
FIGURE 16.
FIGURE 16
26. Position the inlet deflector with
the opening facing the left or the
right side of the filter bag. Slide the
filter bag collar over the inlet deflec-
tor, matching the notches of the bag
collar to the tabs on the inlet
FIGURE 17
deflector. Bag will only fit properly
one way. FIGURE 17.
27. Slide the inlet deflector with the
filter bag attached into the deflector
guide. FIGURE 18.
FIGURE 18
28. Reinsert hose into inlet and
tighten the locking-nut.
FIGURE 19.
FIGURE 19
29. When secured in place, expand the filter bag and
position around the inside of the tank. Replace tank
cover.
NOTE: When removing filter bag from tank, remove the
inlet deflector from the filter bag collar. Reinstall inlet
deflector into deflector guide. Inlet deflector must be in
place for any type of cleaning.
WARNING!
FOR FINE DUST POWDERS
When vacuuming fine dust, or powders of
any kind (plaster, drywall dust,
cold ashes, concrete dust, etc.) a high efficiency
drywall filter bag must be used. When vacuuming
normal household dust and debris, standard household
disposable filter bags may be used.
WET PICK UP
OPERATION
30. Your vacuum can be used for wet pick up. Remove
ALL dirt and debris found in the tank. Remove all
dry use only filters, including the filter bag, from the
vacuum.
31. A clean cartridge filter may be used to pick up small
quantities of liquid. To use the cartridge filter; follow the
cleaning and installation instructions under dry pick up.
32. For vacuuming large quantities of liquid use a foam
sleeve (not standard with all models). A foam sleeve
may be purchased at your local Shop-Vac
®
on the Shop-Vac website, or by contacting Shop-Vac
customer service. To use the foam sleeve; follow the
installation instructions in this section.
33. Misting in the exhaust air or dripping of liquid around
the tank cover may occur if the filter becomes saturated
during wet pick up. If this occurs, remove the filter and
allow to dry, or replace with another dry filter.
34. Turn the unit off immediately upon completing a
wet pick up job or when tank is full and ready to be
emptied. When the tank is full, suction will drastically
reduce. Refer to "automatic suction shut off" in this
manual. Raise the hose to drain any excess liquid into
the tank. Follow the "emptying liquid waste" section in
this manual.
®
distributor,
®
PAGE 7