Storage; Troubleshooting - Shop-Vac CH87 Serie Manuel D'utilisation

STORAGE

FIGURE 22
FIGURE 23
BEFORE DOING ANY WORK ON YOUR VACUUM, TURN THE UNIT OFF AND DISCONNECT THE PLUG
FROM THE WALL OUTLET.
PROBLEM
Loss of suction
wet pick up
Loss of suction
dry pick up
Loss of suction or misting
during wet
pick up
45. Before storing your vacuum
the tank should be emptied and
cleaned. The power cord can be
wrapped around the cord wraps
provided on the top of the tank
cover located in front and behind
the handle. FIGURE 22.
46. To remove the cord from
the cord wraps grasp the sides
of the rear cord wrap located
behind the handle, turn counter
clockwise 180° until the tip
of the cord wrap is above the
handle. FIGURE 23.

TROUBLESHOOTING

CAUSE
Clogged filter
Full tank
Full tank
Clogged filter
Full disposable filter bag
Full tank
Saturated filter
FIGURE 24
FIGURE 25
SOLUTION
Clean filter, see steps 17-21 on page 6 , and
steps 37-40 on page 8.
Empty tank, see step 42 on pg 8.
Empty and clean tank.
Clean filter, see steps 17-21 on page 6.
Remove bag or replace with new.
Drain and clean tank, see step 42 on page 8.
Clean filter, see steps 33 on page 7.
47. Grasp the entire cord behind
the handle and pull above the
rear cord wrap, pull cord towards
the front of the vac until the cord
becomes disconnected from the
front cord wrap. FIGURE 24.
48. Grasp the sides of the rear
cord wrap and turn clockwise
180° to return it to its original
position. FIGURE 25. The
cleaner should be stored
indoors.
PAGE 9