Intended Use; Information About Wireless Operation; Duty Cycle; Included In Delivery - brennenstuhl BREMATIC PRO BM 868 01 3726 Mode D'emploi

Intended use

The wireless motion detector is solely intended to detect moving heat
sources in dry indoor areas and to send a notification to the BrematicPRO
Gateway when triggered.
Any motion detected will be displayed in the app for 1 minute.

Information about Wireless Operation

This device uses the 868.3 MHz proprietary wireless protocol. Wireless
transmission is implemented using a non-exclusive channel, interference
can therefore not be excluded. The range in building may vary greatly
from open areas. In addition to the transmission power and the reception
characteristics of the receivers, ambient conditions, e.g. humidity in
addition to the structural conditions on site, are important factors.
The range can be significantly reduced in part due to:
• Wood, gypsum, concrete, reinforced concrete walls
• Proximity to metal and conductive objects
• Broadband interference, e.g. in residential areas (DECT phones,
mobiles, wireless headphones, wireless speakers, wireless
weather stations, baby monitors)
• Proximity to electric motors, transformers, mains adapters, computers

Duty Cycle

Duty cycle refers to a transmission time limit regulated by law for
devices transmitting in the 868 MHz range. It is intended to ensure
smooth operation of devices operating in the 868 MHz range. The
maximum transmission time of each device is 1 % of an hour
(corresponding to 36 seconds/hour). Once the 1 % limit has been
reached it cannot transmit until the time limit of the duty cycle has
ended, so after one hour.

Included in delivery

1 x Wireless motion sensor
2 x Batteries LR6 / AA / Mignon 1.5 V
3 x Screws
3 x Dowels
1 x Adhesive pad
1 x Quick start guide
1 x Instructions for use (digital, available for download)

Technical data

Product designation: BM 868 01 3726
Item no.: 1294150
Radio frequency: 868.3 MHz
Wireless motion sensor 868.3 MHz
Frequency: 868.1 - 868.5 MHz
Max. transmitting power: < 20 mW
Duty cycle: < 1 % per h
Range: approx. 10 m
Detection angle: approx. 130 °
Supply voltage: 2 x 1.5 V LR6 / AA / Mignon
Power consumption: 30 mA max.
Battery life span: approx. 2 years (typically)
Ambient temperature: 0 °C to 35 °C
Protection type: IP20
Open area range: approx. 100 m
Dimensions (W x H x D): 85.7 x 64 x 32.4 mm
Weight: 96 g
Subject to technical changes without notice.

Device overview

Front

Back

Infrared Motion Sensor
(PIR) with device LED
Pair button
Operating mode
switch
Sabotage switch
Battery compartment
Recess for opening
installation plate
Installation plate with
adhesive pad (optional)
EN 11