Using The Attachment; Attaching/Changing The Sanding Paper Pads; On/Off Switch; Speed Controller - Westfalia 83 65 68 Mode D'emploi

Using the Attachment (e. g. Spade)
1. Lift up the quick change lever (1).
2. Attach the spade (7) to the multi tool.
3. Check the correct fit of the attachment. Make sure
the pins fit exactly into the openings of the
attachment.
4. Low down
attachments can be positioned in an angle of 30°
to both sides of the multi tool, e.g. in line with the housing or on the right or
left side of the housing.

Attaching/Changing the Sanding Paper Pads

The sanding pad holder (9) is equipped with a hook and loop pad, so you easily
and conveniently can change the sanding paper pads (10). Keep the adhesive
fabric of the sanding pad holder free from dirt and dust, so the adhesive fabric will
work as desired.
1. Position one corner of the sanding paper pad to the pad holder and firmly
press it down. For optimal dust extraction, make sure the holes in the sanding
paper pad match the holes in the sanding pad holder.
2. To remove the sanding paper pad, grasp one edge and pull it off the sanding
pad holder.

ON/OFF Switch

1. To switch on the multi tool, push the ON/OFF switch (2) forwards.
2. To switch off the tool, pull the ON/OFF switch (2) back.

Speed Controller

With the speed controller (15) you can adjust the speed
according to application. Select the appropriate speed
setting and make sure the multi tool does not become
overloaded and stops running.
Turn the speed controller steplessly to the desired setting
to increase or decrease the speed. The controller can be
adjusted from 1 – 6. The speed rate can be changed during operation as well.
Hint: The required speed rate for cutting resp. sanding a workpiece depends on
the material that you are going to process. For best performance, make some
practical tests.
All manuals and user guides at all-guides.com
Operation
the quick change lever. The
21