Metronic PIXEL Notice D'utilisation page 6

USE
Connecting (pairing) a phone for the first time
• Turn the speaker on by pressing and holding button
tune sounds.
EN
• Activate Bluetooth on your mobile equipment (see the manual for it if necessary).
• Start a Bluetooth peripheral search. You should see a new peripheral named "metronic
SP55" appear.
• Select this new peripheral in order to activate pairing and connect.
• Once the connection is established, the connection tone sounds and the light
flashing.
Turning off the speaker:
To turn off the speaker, press button
tone sounds and the light
Changing the animation:
A short press of the
front of the speaker.
Stereo use (pair of speakers):
If you are lucky enough to have two Pixel speakers, you can connect them as a pair for high
fidelity stereo listening.
• Connect to one of the speakers using Bluetooth and play some audio content.
• Turn the other speaker on. If it does not automatically connect in stereo playing the same
content as the first speaker, press the
connection, and the speakers will play the same content in stereo.
When you play audio content, this will now be played through both speakers. The volume
control on one speaker controls both.
Note: stereo use only works via Bluetooth.
Disconnecting (unpairing) a pair of speakers
• Press the button on one of the speakers twice to unpair the speakers. The one on which
the light G is flashing blue is ready to be paired with any phone.
Reading a micro SD card / USB stick
You can insert a micro SD card or a USB stick with files in MP3 format into their respective
ports ( or ). The media must be formatted as FAT32 or exFAT. The speaker will automa-
tically play the content of the micro SD card or USB stick. To switch from one mode to the
other, press the
speaker switches to the next mode.
Automatic speaker standby
If your speaker is not connected to any equipment, it automatically puts itself into
standby mode after 15 minutes.
6
-
goes out.
- button allows you to change the animation displayed on the
button twice. A double beep sounds, indicatin
- button twice or unplug the media which is no longer required. The
- . The light
and hold it for 2 to 3 seconds, the standby mode
Technical support: 02 47 346 392
flashes blue, a 3-note
stops