Publicité
Les langues disponibles
Les langues disponibles
Installation Of Power Unit
Place the power unit onto the bracket on the back side of the column with the screws and washes attached
as shown in the following drawing:
Locking washer D.10
Washer D.10
Fit the cylinder is located in the center hole in the column base as shown in the following drawing:
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-09
Hydraulic cylinder
Manufacturer ATH-Heinl GmbH & CO.KG
- 20 -
Screw M10x25
Publicité
