Stage Line electronic MMX-1221 Mode D'emploi page 15

MMX-1221/-1621/-2021
10. AUX1,2
Pre-fader AUX-send controls. The signal level of these sends is independent of
the setting of the channel faders (15).
The pre-fader sends are primarily intended for stage monitoring purposes.
11. AUX 3,4
Post-fader AUX-sends. The output level of these sends is affected by the setting
of the channel faders, so they are well suited for driving effect-devices like delay
units or reverbs.
12. Stereo-Panorama Control PAN
This control allows setting the ratio of distribution of the channel-signal to the left
and right stereo-outputs.
This way the position of the sound source within the main stereo image can be
determined.
13. PFL-Switch / PEAK LED
If the PFL-switch is depressed, the channel signal can be monitored by
headphones.
At the same time the signal level is indicated on the right LED VU-meter.
During PFL-monitoring the red LED below the PFL-switch lights up.
If the PFL-function is not used, this LED works as a PEAK-indicator.
14. Routing Switches MONO, L-R
These switches are provided for selecting the output groups the channel signal
shall be sent to.
Each input channel can be sent to the stereo-outputs L-R and to the MONO-
output. If any of the routing switches is depressed, the green LED "ON" lights up.
15. Channel Fader
High quality 100 mm faders for precise mixdown of the channel-signal to the
output groups MONO and L-R.
Normally the faders should be set to 0 dB, providing 10 dB of gain above that
point if required.
GB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
15